Fronius WF 15i - Adjust the Brake; General; Adjusting the Brake

49
EN
Adjust the brake
General
NOTE!
Risk from brake lag.
This can result in serious damage to property.
► After releasing the torch trigger / wire threading button the wirespool must stop unreel-
ing.
► If it continues unreeling, readjust the brake.
Adjusting the
brake
CAUTION!
Danger from welding current and accidental ignition of an arc.
This can result in severe personal injury and damage to property.
► Before starting work, disconnect the ground earth connection between the welding sys-
tem and the workpiece.
CAUTION!
Danger from emerging wire electrode.
This can result in severe personal injury and damage to property.
► Hold the welding torch with the end directed away from the face and body.
► Wear suitable protective goggles.
► Do not point the welding torch at people.
► Make sure that the wire electrode does not touch any conductive or earthed parts (e.g.
housing).
1 2
1
4
5
STOP
6
7
3
1
2
1
2
1
2