2
Intended Use
Frontier Chippers are designed to chip natural, untreated wood only. Materials that are processed
may contain chemicals or by-products that could corrode the machine, damage the blades, or spon-
taneously combust. Frontier Equipment will not cover under warranty any chipper that has been used
for anything besides natural wood.
Serial Number
The chipper’s serial number is located on the chipper housing just behind the 3-point tractor hookup.
This number helps us to track changes and improvements and must be mentioned when ordering
parts or requesting service. For your convenience, a space has been provided inside the front cover
of this manual to record the serial number, model number, purchase date, and dealer name.
Specications
INTRODUCTION
Specications WC1103 WC1105 WC1205 WC1208
Chip Opening 3 x 5.5 in. (7.5 x 14cm) 5.5 x 8 in. (14 x 20cm) 9 x 16 in (23 x 40.6cm)
Drive System PTO PTO PTO
Engine N/A N/A N/A
Transport 3 Point Hitch
HP Required 16 35+ 80+
Rotor/Drum Size 65 lbs. 165 lbs. 490 lbs.
Knives (2) 2.5 x 3.25 x 5/16 in. (4) 2.5 x 3.25 x 5/16 in. (2) 4.5 x 9 x 5/8 in.
Knife Bolts 3/8” Recessed Head Hardened Bolts 5/8” Grade 8
Feed System Manual Hydraulic
Hydraulic Requirement N/A 6 GPM 8GPM
Feed Roller N/A 12” (30.5cm) 15.5” (39.4cm)
Hopper Opening 25 x 18 in. (62.5 x 45cm) 28 x 28 in. (70 x 70cm) 28 x 42 in (70 x 106cm)
Feed Height 38” (95cm) 41” (102.5cm) 21” (52.5cm) 29.5” (75cm)
Weight (lbs.) 375 650 775 2300
To Next Page
Loading...
