FSK Hawk - Selecting the Alarm Panel Serial Port Format

7 | P a g e
Selecting the Alarm Panel Serial Port Format
1. Press and hold-down the button on the Hawk PCB until
the green RUN lamp stops flashing (turns off).
2. Release the button
3. Press the button successively until the green RUN lamp
flashes the correct number of times, indicating the serial
mode selected
RUN LAMP FLASHES
SERIAL FORMAT
1
Pima
2
Paradox
3
Texecom
4
Rhino
5
IDS
Repeat the process until the correct serial port format has
been selected. The Hawk will remember the setting.
TEST the operation of the radio with the panel after the serial
port format has been selected.