FSR Compass S2 - Page 45

Parameters:
d - led state, 0=off, 1=on
Example:
adbg 1 - turn led1 on
Command: ADLY
Description:
Audio signal delay adjustment for external video device synchronization
Parameters:
t - signal delay time in milliseconds [0..50]
Example:
adly 25 - add 25 ms of audio delay to all channels
Command: AMTE
Description:
Audio mute control
Parameters:
M - Main microphone mute state (0=mute, 1=active)
L - Main line mute state
P - Main source state
m - preview microphone mute state
l - preview line mute state
p - preview source state
Example:
amte 0 0 0 1 1 1 - mute all main audio outputs
Command: AOUT
Description:
Audio output relay control to enable or disable main, preview and headphone relays.
Parameters:
P - main relay control (0=off, 1=on)
p - preview relay control
h - headphone relay control
Example:
aout 1 1 1 - enable all outputs
Command: ARST
Description:
Audio board reset control
Parameters:
u - reset the audio board uart if 1
Example:
arst 1 - resets the uart
Compass S
2
37