Command: ARTE
Description:
Route audio router inputs to output channels a and b.
Parameters:
a - channel a input [0..8], where 8 is the silent channel
b - channel b input [0..8], where 8 is the silent channel
Example:
arte 0 8 - route input channel 1 to output a and the silent channel to output b
Command: ARTEM
Description:
Route audio main channel
Parameters:
c - input [0..8], where 8 is the silent channel
Example:
artem 0 - route input channel 1 to main
Command: ARTEP
Description:
Route audio preview channel
Parameters:
c - input [0..8], where 8 is the silent channel
Example:
artep 8 - route silent channel to preview
Command: ASEN
Description:
Audio sensitivity settings for audio source inputs, line input, microphone gain and microphone
phantom power.
Parameters:
p - phantom power setting (0=off, 1=on)
m - microphone gain settings 1=-43dB, 2=-50dB, 3= -53dB
l - line level setting (0=consumer, 1=professional)
s - source level setting bits (0=consumer, 1=professional)
Example:
asen 0 1 0 0x01 - set the phantom power off, gain to -43dB, line level to consumer and source 1 to
professional (notice that the source level setting is an eight bit value)
Command: ASTAT
Description:
Factory use only, returns a number of status bytes indicative of the current audio state.
Parameters:
None
Example:
astat
38 Compass S
2
To Next Page
Loading...