nnn - [-100 - 100] Absolute value determines the speed at which the knob is rotating and must be
greater than 2. Positive values indicate Counter-Clockwise motion. Negative values indicate
Clockwise motion.
Example:
TER 4 : “Move” the knob in a Counter-Clockwise motion by a small amount.
Command: TKC nn
Description:
Allows a remote control unit to emulate the function of any switch on the front panel.
Parameters:
nn - [06 – 7F], Each switch has a unique hex code association. This number needs to be
transmitted in ASCII format. See the table below.
SWITCH NAME CODE
TKC <hex value in ascii>
(e.g. TKC 2e)
CUT B
DISSOLVE D
AUDIO1 MUTE 19, 1a..21
VIDEO1 BLK 24, 25..2C
A/V MODE 2E
OUTPUT SETUP 11
INPUT SETUP 12
EFFECT 13
MISC 1
FILE 2
AUDIO 3
SEL 18
ESC 15
Virtual Main Switching Keys
Main AUDIO1 MUTE 39, 3a..41
Main VIDEO1 BLK 44, 45..4C
Example:
TKC 12: Makes the system respond as if the WIPE key had been pressed.
Command: TLSR
Description:
Returns a 46 byte ASCII string indicating the status of the Front Panel LEDs.
Parameters:
None.
Example:
TLSR: Refer to the Terminal Remote Control section of this document for further information on
the format of this string.
Command: TRCF n nn
Description:
Sets the File Association table.
Parameters:
50 Compass S
2
To Next Page
Loading...