FSR Compass S2 - Technical Specifications

n - Input Source n[1 – 8]
nn - File Number nn[1 – 64]
Example:
TRCF 4 2: Sets up Input source 4 to use File 2.
Command: TRN dst dn n.n n
Description:
Use to transition Preview onto the Main output display.
Parameters:
dst - Final Input; dst[A|B|M|P] n – 0
dn - Transition Number: 1
n.n - Fade Rate in seconds; n[0 - 5.0, 9.0], where 9.0 = Manual Mode
Example:
TRN P 1 4.9 0: Dissolve Preview onto Main with a fade rate of 4.9 seconds.
TRN A 1 9.0 0: Place system into Manual transition mode. The T-Bar command (see above) will
perform the dissolve. The dst parameter is ignored when placing the system into
manual mode. Executing a TRN command like that in the first example will take the
system out of manual transition mode.
Command: UL
Description:
Upload Input File configurations or a Program Sequence to the Compass S2.
Parameters:
op - Input configuration; [I|P]
nn - Index Number; [0-64]
s[8]- Used to override description of file uploaded.
Example:
UL I 2 : Upload input configuration to index 2.
UL I 0 : Upload input configuration to the index it originated from.
UL P 1 : Upload a Program Sequence configuration.
Command: VBW
Description:
Video Bandwidth adjustment.
Parameters:
n - Bandwidth setting; n[0|1] FULL | REDUCED
sclr - Scaler [A|B|M|P]; Scaler A | Scaler B | Main | Preview
Example:
VBW 0 P : Set the video bandwidth on Preview to Full.
Command: VER?
Description:
This is a version query. The return format is nn.nn.a where:
nn is a two digit software version
nn is a two digit software version
a is an alpha character
Parameters:
None
Example:
VER?: Will return =nn.nn.a to a terminal emulator.
Command: VPK
Compass S
2
51