Need help?Do you have a question about the FuelTech FT500 and is the answer not in the manual?
General| ECU Type | Standalone |
|---|---|
| Number of Injector Outputs | 8 |
| Number of Ignition Outputs | 8 |
| Lambda Input | Yes |
| Data Logging | Yes |
| Gear Controller | Yes |
| Boost Controller | Yes |
| Nitrous Controller | Yes |
| Internal MAP Sensor | Yes |
| Inputs | 16 |
| Outputs | 16 |
| Communication | CAN |
| Operating Temperature | -20°C to 85°C |
Covers essential engine configuration like type, cylinders, boost, and RPM limits.
Details settings for ignition modes, outputs, and fuel injection configurations.
Describes the process of generating a default base map for engine tuning.
Explains the 12V input, sensor power, and crucial ground wire connections.
Guides on configuring ignition systems, including distributors and coils.
Details the crucial process of calibrating the throttle position sensor and pedal.
Details the calibration process for O2 sensors, including alcohol and wideband types.
Guides on initial engine start procedures, checks, and safety precautions.
Details the critical steps for performing ignition calibration to ensure accurate timing.
Details how to adjust main fuel tables, overall fuel trim, and RPM compensation.
Explains the O2 closed loop function and setting idle speed based on TPS.
Guides on adjusting main ignition tables, overall trim, and MAP/TPS compensation.
Explains how to set up and configure idle speed control using various methods.
Details how to configure deceleration fuel cut-off and engine RPM limiters.
Details the setup for progressive nitrous injection systems.
Details the configuration of burnout mode and 2-step/3-step launch control.
Guides on enabling Pro-Nitrous, setting TPS limits, and configuring stages.
Guides on generating base maps and performing file operations like copying and erasing.
To Next Page
