1-2
1-3 Handling of the product
(1) Removing the front cover
Loosen the mounting screws of front cover and remove the front cover by holding its upper part with
hands as shown in Fig. 1-3-1.
Mounting screws
of front cover
Fig. 1-3-1 Removing the front cover
1-4 Carrying
When carrying the product, hold only the main body of the product surely.
If holding the cover or parts, it may result in damage or fall-off.
1-5 Storage
Storage the products in the environment as shown in Table 1-5-1.
Table 1-5-1 Storage environment
Item Specification
Ambient.
temperature
–10 to +50°C
Storage
∗
1
temperature
–25 to +65°C
Relative humidity
5 to 95%
∗
2
The location without condensation or freezing by sharp
temperature change
Atmosphere
Without dust, direct sunlight, corrosive gas, inflammable gas, oil mist, vapor,
water drop and vibration
Not including too much of salt
∗1: The storage temperature means in a case of a short time such as transport.
∗2: Although the humidity conforms to the specified value, condensation or freezing occurs in a
location of large temperature change. Avoid such location.
① Do not put the product directly on a floor.
② If the surrounding atmosphere is not good, store the product packed with a vinyl sheet etc.
③ If the humidity may affect the product, put a desiccant ( such as silica gel) into the package as shown
in .
To Next Page
Loading...
