2-6
(5) Wiring of the control circuit
① Lead out the cable along the left side panel as shown in Fig. 2-3-5.
② Secure the cable to cable-tie holder on the left wall of the main circuit terminal block on the way of lead out
using a cable-tie (e. g. insulock). The cable-tie must not exceed 3.5mm or less in width and 1.5 mm or less
in thickness to pass through a rectangular hole (3.8×1.5).
Cables of
control circuit
Side panel (LEFT)
Cables
Cable-tie
Cable-tie
holder
Fig. 2-3-5 Route of control circuit wiring
To Next Page
Loading...
