Fuji Electric MICREX-SX SPH Series - Appendix 2-3-9 Individual Stop of CPU; Appendix 2-3-10 Individual Reset of CPU

App.2-9
Appendix 2-3 Loader Command Details
Appendix 2-3-9 Individual Stop of CPU
1) Function
This command deactivates a specified CPU in the configuration separately.
If the specified CPU has already been deactivated or the key switch is set to the RUN/STOP position, an error result. CPU
specification is made with the connection mode and connection ID.
2) Command/mode code
Command: 04h, Mode: 06h
3) Data format of request command/response command
None
4) Example of individual stop command of CPU
When deactivating a CPU separately (CPU1 in a multi-CPU system), request and response commands are as shown
below.
Request command : FF7BFD00110000000000040600010000
Response command : 007BFD00110000000000040600010000
Appendix 2-3-10 Individual Reset of CPU
1) Function
This command resets a specified CPU in the configuration separately.
If the key switch is set to the RUN/STOP position, an error result. CPU specification is made with the connection mode and
connection ID.
2) Command/mode code
Command: 04h, Mode: 07h
3) Data format of request command/response command
None
4) Example of individual reset command of CPU
When resetting a CPU separately (CPU1 in a multi-CPU system), request and response commands are as shown below.
Request command : FF7BFD00110000000000040700010000
Response command : 007BFD00110000000000040700010000