20
3
Parameter functions and setting procedure
3-1 1st block parameter
MANU
Manual mode selection (001)
[Description] –––––––––––––––––––––––––––––––––––––––––––––––––––––––
Allows you to select how to set the manipulated variable, automatically or manually.
Setpoint
Description
oFF
Automatically
oN
Manually
MANU indicator lights during manual operation. (see page 11)
In this screen, only the switchover between auto/manual is available. Manual operation of control output is
available on PV/MV screen.
This parameter is not displayed in default setting. To use this parameter, change the
setting of the parameter “Parameter mask” (see page 68).
[Setting example] Changing the mode from Auto to Manual –––––––––––––––––
Display Operating procedure
1.
Press and hold the key for about one second during the SV/PV display.
appears.
2.
Press the key.
The setpoint starts blinking.
3.
Press the or keys to change “ oFF ” to “ oN .”
4.
Press the key or wait for three seconds to save the change.
5.
Press the key.
The screen returns to the SV/PV display.
To Next Page
Loading...
Need help?
General
