Fuji Electric POD UG221H-LR4 - System Error; Touch Switch Is Active

7-4 1. Error Message
4. SYSTEM ERROR
When a system error is detected, the following error screen is displayed on the POD.
ERROR: XX
1: Watch dog timer error
11: Switch table error
30: Request for displaying full error
31: Memory allocation system error
32: General exceptions/MMU address system error
33: RTOS system error
34: Memory error
35: Inaccurate memory error
The source of the error could be one of the following three problems. Contact your local distributor.
1) Program crash due to noise
2) Hardware problem
3) Bad program
Solve relevant problems by following the directions in “Troubleshooting” (page 7-5).
If the problem persists, contact your local distributor.
5. Touch Switch is Active
If the power is turned off while a touch switch is
activated, the error screen shown on the right is
displayed.
Remove your finger from the screen.
If the error screen remains displayed, contact your
local distributor.
SYSTEM
F2
F3
F4
F5
F1
POWER
SYSTEM ERROR : 32
TEA : XXXXXXXX
SSR : XXXXXXXX
R0 : XXXXXXXX
R2 : XXXXXXXX
R4 : XXXXXXXX
R6 : XXXXXXXX
R8 : XXXXXXXX
R10 : XXXXXXXX
R12 : XXXXXXXX
R14 : XXXXXXXX
EXPEVT : XXXXXXXX
SPC : XXXXXXXX
R1 : XXXXXXXX
R3 : XXXXXXXX
R5 : XXXXXXXX
R7 : XXXXXXXX
R9 : XXXXXXXX
R11 : XXXXXXXX
R13 : XXXXXXXX
R15 : XXXXXXXX
SYSTEM
F2
F3
F4
F5
F1
POWER
Check
Touch Switch is active.
Keep hand off the screen.