Fuji Electric TP-A1 - Running;Stopping the Motor

3-11
ENGLISH
3.3.3 Running/stopping the motor
FRENIC-HVAC/AQUA series
By factory default, pressing the or
key starts running the motor in the forward
or reverse direction, respectively. Pressing
the
key decelerates the motor to a stop.
Running/stopping the motor from the
keypad is possible in Running or
Programming mode.
FRENIC-Ace series
By factory default, pressing the
key
starts running the motor in the forward
direction. Pressing the
key decelerates
the motor to a stop. The
key is
disabled.
Running/stopping the motor from the
keypad is possible in Running or
Programming mode.
To run the motor in the reverse direction or
to run it in the reversible mode, change the
setting of function code F02.
 Operational relationship between function code F02 (Operation method) and
/
key
Table 3.6 Motor Rotation Direction Specified by F02
Data for F02 Motor rotation direction
(Note) The rotation direction of IEC-compliant
motors is opposite to that of the motor shown
here.
0
key: Forward direction
key: Reverse direction
(Factory default of the FRENIC-HVAC/AQUA
series)
1
and
keys disabled
(The motor is driven via terminals [FWD] and
[REV].)
2
Forward direction
(Factory default of the FRENIC-Ace series)
3 Reverse direction
 For details of function code F02, refer to the inverter's Instruction Manual, Chapter 6 "FUNCTION CODES."
Program
key
STOP key
Run ke
y
(forward)
LED indicators
Run ke
y
(reverse)
RESET key
LCD monito
r
Operation
keys
HELP key
SET key
UP/DOWN/LEFT/RIGHT arrow key