Fuji Electric TP-A1 - Notes (Difference between Multi-Function Keypad and Remote Keypad); Operation Method (Function Code F02); Remote and Local Modes

3-17
ENGLISH
3.5 Notes (Difference between multi-function keypad and remote keypad)
In addition to the multi-function keypad (TP-A1-, this product), a remote keypad is also available. Be
careful with the operational differences between those keypads.
3.5.1 Operation method (Function code F02)
The multi-function keypad has the
, ,
keys so that no rotation direction command is required while
the remote keypad has the
and keys.
Data for F02 Run command source
0: Keypad Enable the / / keys to run and stop the motor.
1: External signals Enable terminal command FWD and REV to run and stop the motor
2: Keypad (Forward rotation) Enable / keys to run and stop the motor. Note that this run
command enables only the forward rotation (The
key is disabled.)
3: Keypad (Reverse rotation) Enable / keys to run and stop the motor. Note that this run
command enables only the reverse rotation (The
key is disabled.)
3.5.2 Remote and local modes
The multi-function keypad has the
key. Holding it down for 2 seconds or more switches between remote
and local modes.
 Remote mode: The run and speed command sources are determined by source switching signals including
function codes, run command 2/1 switching signal, and communications link operation signal.
The keypad cannot be used as a command source.
 Local mode: The keypad is enabled as a run and speed command source, regardless of the settings
specified by function codes. The keypad takes precedence over run command 2/1 switching
signal, communications link operation signal or other command sources.
The table below lists the run command sources using the keypad in the local mode.
Data for F02 Run command source
0: Keypad Enable the / / keys to run and stop the motor.
1: External signals Enable terminal command FWD and REV to run and stop the motor
2: Keypad (Forward rotation) Enable / keys to run and stop the motor. Note that this run
command enables only the forward rotation (The
key is disabled.)
3: Keypad (Reverse rotation) Enable / keys to run and stop the motor. Note that this run
command enables only the reverse rotation (The
key is disabled.)

For details, refer to Section 3.3.5 "Switching between the remote and local modes."