2
2.2 Mounting the Multi-function Keypad
You can install and use the multi-function keypad in either of the following two ways:
- Mounting it on the panel (see Figures 2.1 to 2.3).
- Using it remotely in your hand (see Figure 2.3).
Mounting the multi-function keypad on the panel
(1) Cut the panel out for a single square area and perforate two screw holes on the panel wall as shown below.
Make screws of an appropriate length ready for use.
(Unit: mm)
Figure 2.1 Location of Screw Holes and Dimension of Panel Cutout
To Next Page
Loading...