2-3
(2) Mount the multi-function keypad on the panel wall with 2 screws as shown below. (Recommended
tightening torque: 0.7 N•m)
Figure 2.2 Mounting the Multi-function Keypad
(3) Using the remote operation extension cable (CB-5S, CB-3S or CB-1S) or a LAN cable (straight),
interconnect the keypad and the inverter; Insert one end of the cable into the RJ-45 connector on the
keypad and the other end into the RJ-45 connector (modular jack, designed for keypad connection) on the
inverter.
Figure 2.3 (a) FRENIC-Ace
Connecting the Multi-function Keypad to the Inverter with Remote
Operation Extension Cable or an Off-the-shelf LAN Cable
Remote operation
extension cable
(CB-5S, CB-3S, CB-1S)
or LAN cable
RJ-45 connector (modular jack)
Panel
Multi-function
keypad
RJ-45 connecto
ENGLISH
To Next Page
Loading...