3-16
Table 3.7 Programming Mode Menus (Continued)
Main
Menu
Sub-Menu
Hierarchy
Display
Principal Functions
FRENIC-AQUA
FRENIC-HVAC
FRENIC-Ace
3. INV Info: Allows monitoring of inverter operational status.
1 Power monitor PRG>3>1 Monitors the input watt-hour.
Y Y N
2 Operation monitor PRG>3>2 Displays the running information. Y Y Y
3 I/O check PRG>3>3 Displays external interface information. Y Y Y
4
Maintenance
information
PRG>3>4
Displays the cumulative run time and other information
to be used for maintenance.
Y Y Y
5 Unit information PRG>3>5
Allows you to check the inverter type, serial number
and ROM number.
Y Y Y
4. Alarm Info: Displays alarm information.
1 Alarm history PRG>4>1
Lists alarm history (newest + 9 previous). Detailed
information can be confirmed for the four most recent
occurrences.
Y Y N
Lists alarm history (newest + 3 previous). Detailed
information can be confirmed for the four most recent
occurrences.
N N Y
2
Light alarm
(Warning) history
PRG>4>2
Lists light alarm history (newest + 5 previous).
Y Y N
Lists light alarm history (newest + 3 previous). N N Y
3 Retry history PRG>4>3 Displays retry history (two instances). Y Y Y
5. User Config: Allows any settings to be made.
1
Quick setup
selection
PRG>5>1
Allows function codes to be added to or deleted from
the "0. Quick Setup" display.
Y Y Y
2 Password PRG>5>2
Allows setting to prevent inverter function code access
or data revision.
Y Y N
6. Tools: Various functions
1 PID monitor PRG>6>1
Allows status of PID controls 1 and 2 and external PID
controls 1, 2 and 3 to be monitored. (PV, SV, MV, etc.)
Y Y Y
2
Unit number
control monitor
PRG>6>2
Allows confirmation of the operational status on the
pump number control.
Y N N
3 CLogic monitor PRG>6>3 Previews and debugs customized logic. Y Y Y
4
Resonance
prevention
PRG>6>4
During operation, allows jump frequency to be set
while confirming resonance status.
Y Y Y
5
Load factor
measurement
PRG>6>5
Allows measurement of the operational status of the
maximum output current and average output current.
Y Y Y
6 COM debug PRG>6>6
Allows monitoring and setting of
communication-specific function codes (S, M, W, W1,
W2, W3, X, X1, Z).
Y Y Y
Non-supported functions are displayed with a mark instead of the sub-menu number.
To Next Page
Loading...