2 Paper and Other Media
44
Paper and Other Media
2
1
Pull out the tray halfway until it stops.
Important • While the machine is processing a job, do not
pull out the tray that is being used for the job.
• To prevent paper jams or erroneous
detection of loaded paper in a tray by the
machine, do not add paper on top of any
remaining paper in the tray. Remove any
remaining paper from the tray, and then load
that paper on top of the newly loaded paper.
2
Hold the tray with both hands, and remove it
from the machine.
3
Adjust the paper guides.
Note • When loading Legal size or user-specified
paper, slide the extendable part of the tray
while pinching the lever.
4
Before loading the paper, flex the sheets and fan them. Straighten the edges of the stack
on a level surface.
5
Load the paper into the tray with the recommended print side facing up.
Note • Do not exceed the maximum fill line in the tray. Overfilling the tray may cause paper jams.
• When loading coated paper, load coated paper one sheet at a time.
• When loading letterhead or hole punched paper, load paper from the top edge and with the
recommended print side facing up.
6
Align the width guides and length guide
against the edges of the paper.
To Next Page
Loading...
