Job Assembly
145
Copy
3
Sample Job (Checking the Finished Output of the Copy)
When making multiple sets of copies, you can print a sample set to check the finished output
and then print the remaining copy sets. You can select whether to continue or cancel the job
after the confirmation. This feature also allows you to change the number of copy sets. The
sample copy is included in the total number of copy sets.
Note •After a sample set is output, if the machine is left uninstructed for the period specified in [Auto
Clear], you can set whether or not to start the data remained. For more information, refer to "5
Tools" > "Common Service Settings" >"Other Settings" > "Paused Job Handling".
For more information on [Auto Clear], refer to "5 Tools" > "Common Service Settings" > "Machine
Clock/Timers" > "Auto Job Release" in the Administrator Guide.
1 Select [Sample Job].
2 Select [On].
Off
No sample set is made.
On
A sample set is made.
[Copy] Screen When Sample Job is in Progress
After the sample set is copied, the machine
pauses the job and displays the [Copy] screen.
Change Quantity
Displays the [Change Quantity] screen on which
you can change the number of copies entered
before. Enter a new quantity using the numeric
keypad. The new value must include the
number of the sample set that has already been
printed. When reducing the quantity, specify a value between 1 (sample set) and the
number of copies entered before.
Note •If you specify "1" as a new quantity and then press the <Start> button, the machine will not process
the job.
Change Settings
Displays the [Change Settings] screen. To cancel the settings you have made, deselect the
check box for the feature you want to cancel.
Delete
The remaining copies are canceled.
Start
The remaining copies are made.
Note •You can also press the <Start> button on the control panel to perform the same operation.
To Next Page
Loading...
Need help?
General
