Fuji Xerox DocuCentre-IV C3373 Administration Guide

Interface Cables
21
Before Using the Machine
1
Interface Cables
When you connect he machine directly to your computer, use the USB interface. When you
connect the machine to a network, use the Ethernet interface.
Using the USB Interface
The USB interface of the machine supports USB 2.0.
This section describes the installation procedures for the USB interface.
1 Press the power switch to the [ ] position to switch off the power.
2 Make sure that the touch screen is blank and the <Energy Saver> button does not light up.
3 Open the front cover.
4 Press the main power switch to the [ ] position to switch off the main power.
5 Remove the rear right cover.
6 Connect the USB cable to the USB 2.0 interface
connector.
7 Return the rear right cover to its original
position.
8 Connect the other end of the USB cable to the computer.
9 Press the main power switch to the [ | ] position to switch on the main power.
10 Close the front cover.
11 Press the power switch to the [ | ] position to switch on the power.
12 Restart the computer.

Fuji Xerox DocuCentre-IV C3373 Specifications

General

Print Resolution	1200 x 2400 dpi
Functions	Print, Copy, Scan, Fax
Memory	2 GB
Hard Disk Drive	160 GB
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Yes
Connectivity	USB, Ethernet
Paper Size	A3, A4, A5, B4, B5
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows, Mac, Linux
Print Speed	Up to 33 ppm (color/black)