14 Authentication and Accounting Features
432
Authentication and Accounting Features
14
Configuration for IC Card Reader (Optional)
You can use a smart card for authentication by comparing the information registered on the
smart card and the user information on the machine. You can also restrict the machine use
and perform accounting of the jobs using the information registered on the smart card.
This section describes the supported smart cards and how to register a smart card to use at
the machine.
Note • An optional component is required to use this feature. For more information, contact our Customer
Support Center.
The following shows the reference section for card information and each procedure.
Step 1 Preparations..................................................................................................................................................................... 432
Step 2 Logout Method Using the Smart Card ...................................................................................................................... 432
Step 3 Registering Smart Card Information ......................................................................................................................... 433
Step 1 Preparations
Two types of IC Card Reader are supported by the machine. Each IC Card Reader supports
following smart card types.
îš„ When using DENSO PR-450UDM
z
MIFARE
®
(Type A)
- Fuji Xerox IC Card (Type A)
- Other MIFARE compatible smart cards*
z
eLWISE/ELWISE (Type B)
-eLWISE
-ELWISE
z
FeliCa
®
- Fuji Xerox IC Card
- IC Card compatible with SSFC version 1.0 format
- Other FeliCa compatible smart cards*
* : The embedded IC Card Reader of the machine may not support some smart cards.
îš„ When using TWN3 Version HIDPROX
z
HID-PROX*
* : The embedded IC Card Reader of the machine may not support some smart cards.
Note • When you confirm which IC Card Reader you use, contact our Customer Support Center.
Step 2 Logout Method Using the Smart Card
Perform the following steps to set how to logout authentication using the smart card.
1 Press the <Log In/Out> button.
2 Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's passcode,
and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
To Next Page
Loading...
Need help?
General
