Fuji Xerox DocuCentre-IV C3373 Administration Guide

Connectivity & Network Setup
213
Tools
5
 Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important •Do not use the numbers assigned to the other ports.
 Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 88.
Important •Do not use the numbers assigned to the other ports.
 Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server 2003, or Windows
Server 2008 as server, specify the domain name of Active Directory in [Domain Name]. Up
to 64 characters are allowed.
Important •Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
LDAP Server/Directory Service Settings (ApeosPort Series Models Only)
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
 Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Primary Server - Port Number
Set the Primary server port number from 1 to 65535.
The default value is 389.
Important •Do not use the numbers assigned to the other ports.
 Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Secondary Server - Port Number
Set the secondary server port number from 1 to 65535.
The default value is 389.
Important •Do not use the numbers assigned to the other ports.

Fuji Xerox DocuCentre-IV C3373 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV C3373
Category	All in One Printer
Language	English