5 Tools
242
Tools
5
G3 Sender ID - IP Fax
When using G3 communications, you can select whether to notify G3-ID to recipients for
fax.
G3 Sender ID - IP Fax (SIP)
For G3 communications, you can select whether to notify G3-ID to recipients for IP Fax
(SIP).
Save Undelivered Faxes
Set whether or not to save a fax document if a fax transmission fails. When [Yes] is selected,
the [Undelivered Faxes] button appears on the [Secure Print Jobs & More] tab of the [Job
Status] screen. Select this button to send the fax document again.
For details on Undelivered Faxes, refer to "11 Job Status" > "Printing and Deleting Stored Jobs" > "Undelivered Faxes" in the
User Guide.
Save Deleted Faxes
When [Yes] is selected for [Save Undelivered Faxes], set whether or not to save cancelled
faxes.
Saved Faxes - Auto Delete
When [Yes] is selected for [Save Undelivered Faxes], set whether or not to automatically
delete saved faxes in 24 hours.
Transmission Interval
Specify a value for the interval between the end of one transmission and the beginning of
the next, from 3 to 255 seconds in 1 second increments.
A longer transmission interval increases the total time to send a broadcast transmission, but
allows calls to be received during the standby time.
Batch Send
When the machine stores multiple faxes addressed to a destination, enabling the Batch
Send feature allows you to send them all at the same time in a single fax transmission. By
using this feature, you can reduce your communication costs.
Select whether or not to enable the Batch Send feature.
Note that a batch send is not available for manual transmissions, broadcasts, relay
broadcasts, remote folder, and delayed start transmission with a specified time before the
specified time. When a redial, resend, delayed start transmission job, or the Authentication
feature is used and different users send to the same address, a batch send is not possible.
Manual Send/Receive Default
When on-hook or off-hook is used when sending a fax, select either [Manual Receive] or
[Manual Send].
Note • This setting is not valid for IP fax (SIP) because the IP Fax feature does not offer the Manual Send/
Receive feature option.
Fax Receiving Mode
Set the default value for [Fax Receiving Mode] in the [Machine Information] screen
displayed by pressing the <Machine Status> button. Select whether or not to receive a fax
automatically or manually.
Note • As for IP fax (SIP), the machine always receives faxes automatically.
To Next Page
Loading...
Need help?
General
