Installation When Using TCP/IP (LPD/Port 9100)
323
Printer Environment Settings
7
Installation When Using TCP/IP (LPD/Port 9100)
This section describes how to install the machine using TCP/IP.
The following shows the reference section for each procedure.
Step 1 Preparations .....................................................................................................................................................................323
Step 2 Configuration on the Machine.....................................................................................................................................323
Step 3 Configuration on the Computer ..................................................................................................................................324
CentreWare Internet Services Setting Items.........................................................................................................................324
Step 1 Preparations
The following items are required to use the machine via TCP/IP (LPD/Port 9100).
z
TCP/IP network environment
z
The Driver CD Kit (provided with the machine)
z
The Adobe PostScript 3 Kit (optional) - this is required only when using a Macintosh
computer
Note • For Mac OS 9.2.2 English, and Mac OS X 10.3.9 - 10.4.11/10.5/10.6/10.7 English, Adobe PostScript3
Kit (optional) is required to use the LPD port. However, for Mac OS X 10.5/10.6/10.7 English, you can
use LPD port without Adobe PostScript 3 Kit (optional) if you install the print driver for Mac OS X
contained in the CD-ROM provided with the driver.
• For Mac OS X 10.6, you can use the Port9100 port without the Adobe PostScript 3 Kit (optional) if
you install the print driver for Mac OS X.
Step 2 Configuration on the Machine
The following describes the configuration procedures to use TCP/IP (LPD/Port 9100) on the
machine. Enable the LPD Port or the Port 9100 port, and then configure TCP/IP settings.
Note • You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet Services Setting
Items" (P.324). For information on how to configure the setting using the Driver CD Kit, refer to the manual contained in the
Driver CD Kit.
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the LPD port or Port 9100 port as appropriate.
In this example, the LPD port is enabled.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [LPD], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
To Next Page
Loading...
Need help?
General
