5 Tools
274
Tools
5
z
Resend Attempts
Set the transmission retry count from 1 to 5.
z
Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
îš„ Encryption
Set whether or not to encrypt the e-mail transmission.
Note • To encrypt e-mail transmission, the configuration of S/MIME is required.
• To encrypt e-mail transmission, a certificate is required.
• To enable encryption, select [On] before specifying an address. [On] will be disabled after an address
is specified.
îš„ Digital Signature
Select whether or not to add digital signature.
Note • To add digital signature, the configuration of S/MIME is required.
• To add digital signature, a certificate is required.
Transfer via FTP (1), Transfer via FTP (2)
[Transfer via FTP (2)] will be displayed when [Transfer via FTP (1)] is configured.
Specify where FTP forwarding is to be stored.
îš„ Address Book
When the server address is registered on the Address Book, you can specify the address from
the Address Book. The specified address appears in the [Transfer via FTP (1)] or [Transfer via
FTP (2)] screen.
For more information on the Address Book, refer to "Add Address Book Entry" (P.277).
îš„ File Format
Specify an output file format.
For more information on the [File Format] screen, refer to "5 Scan" in the User Guide.
îš„ Resend Attempts
Set whether or not to try sending again if a transmission fails. If you select [On], set the
number of resend attempts and interval.
z
Resend Attempts
Set the transmission retry count from 1 to 5.
z
Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
îš„ Name, Server, Save in, User Name, and Password
Select [Name], [Server], [Save in], [User Name], or [Password] to display an input screen.
The numbers of characters you can input are as follows:
z
Name: Up to 18 single-byte characters
z
Server: Up to 64 single-byte characters
z
Save in: Up to 128 single-byte characters
z
User Name: Up to 97 single-byte characters
z
Password: Up to 32 single-byte characters