15 Problem Solving
562
Problem Solving
15
116-710
[Cause] The correct document size could not be judged because the receive data exceeded the
HP-GL/2 (optional) spool size.
[Remedy] Increase the size assigned to HP-GL/2 auto layout memory.
116-713
[Cause] The data has been divided into a number of jobs because of insufficient disk space.
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
116-714
[Cause] An HP-GL/2 (optional) command error occurred.
[Remedy] Check the print data.
116-716
116-717
[Cause] An error occurred when reading the data on the media.
[Remedy] On a computer, confirm the content recorded on the media.
116-720
[Cause] An error occurred during print processing because of insufficient memory.
[Remedy] Stop unnecessary ports or delete unnecessary data to free up disk space.
116-725
[Cause] Failed to write the image log because the image log storage area on the machine is
insufficient.
[Remedy] Execute the operation again.
If this error still is not resolved, take one of the following measures:
z
Delete unnecessary image logs.
z
Change the [Assurance Level] setting for image logs to [Low].
In this case, selecting [Low] does not secure the contents of created image logs.
116-738
[Cause] The size and orientation of the form specified are not matched with the paper to be
printed.
[Remedy] Match the size and orientation of the paper with the form specified, and print again.
116-739
[Cause] The form or logo data cannot be registered because memory for the form and logo data
or memory capacity for the hard disk is insufficient.
[Remedy] Delete unnecessary data, or free up the space for the form memory.
116-740
[Cause] A numerical value operation error occurred because a value exceeding the value limit of
the machine was used in the print data.
[Remedy] Check the print data.
116-741
[Cause] The form cannot be registered because the number of the form registration exceeds the
maximum number allowed.
[Remedy] Delete unnecessary form. The maximum number allowed is 2048.
116-742
[Cause] The logo data cannot be registered because the number of the logo data registration
exceeds the maximum number allowed.
[Remedy] Delete unnecessary logo data.
116-743
[Cause] The logo data or form cannot be registered because the memory for the form and logo
data is insufficient.
[Remedy] Increase memory.
116-746
[Cause] The form specified is not registered.
[Remedy] Use the form registered, or register the form.
116-747
[Cause] The paper margin value is too large for the HP-GL/2 (optional) active coordinates area.
[Remedy] Decrease the paper margin value, and then execute the operation again.
116-748
[Cause] There is no plot data in the HP-GL/2 (optional) print data.
[Remedy] Check the print data.
Error Code Cause and Remedy
To Next Page
Loading...
Need help?
General
