Configuration of Scan to My Folder (ApeosPort Series Models Only)
337
Scanner Environment Settings
9
Configuration of Scan to My Folder (ApeosPort Series Models Only)
This section describes how to configure the machine to use the Scan to My Folder service.
The following shows the reference section for each procedure.
Step 1 Preparations .....................................................................................................................................................................337
Step 2 Enabling SMB Port and Setting up TCP/IP................................................................................................................337
Step 3 Configuring Remote Authentication ..........................................................................................................................338
Step 4 Configuring Scan to My Folder ....................................................................................................................................339
Step 5 Configuration on the Computer ..................................................................................................................................341
Step 1 Preparations
The Scan to My Folder service allows you to forward scanned files to recipients which vary
depending on a login user when [Login to Remote Accounts] is selected for [Login Type].
The following items are required to use the Scan to My Folder feature.
îš„ Remote Authentication System
To use the Scan to My Folder service, a remote authentication system is required.
For more information about a remote authentication system, refer to "Authentication System" (P.193).
îš„ Destination Computer
The following operation system must be installed on a destination computer.
For Mac OS X, a sharing user account is required on the Mac OS X.
z
Microsoft Windows 2000
z
Microsoft Windows Server 2003
z
Microsoft Windows Server 2008
z
Microsoft Windows Server 2008 R2
z
Microsoft Windows Server 2012
z
Microsoft Windows Server 2012 R2
z
Microsoft Windows Vista
z
Microsoft Windows 7
z
Microsoft Windows 8
z
Microsoft Windows 8.1
z
Mac OS X 10.4.11 Tiger
z
Mac OS X 10.5 Leopard
z
Mac OS X 10.6 Snow Leopard
z
Mac OS X 10.7 Lion
z
OS X 10.8 Mountain Lion
Step 2 Enabling SMB Port and Setting up TCP/IP
To use Scan to My Folder service, enable the SMB port and set the IP address. The following
describes the configuration procedures on the machine.
To Next Page
Loading...
Need help?
General
