Fuji Xerox DocuCentre-V C3375 Administrator's Guide

Connectivity & Network Setup
221
Tools
5
ThinPrint
 Port Status
You can use the machine for print in the ThinPrint
®
.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
 Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any number s assigned to the other ports.
Note • ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition. (Type 2 (T2) model only)
Ethernet Settings
Configure the Ethernet settings.
 Ethernet1 - Network Name, Ethernet 2 - Network Name (Type 2 (T2) model only)
When two Ethernet interfaces are used, specify the names respectively.
Note • This item is displayed only when Secondary Ethernet (optional) is installed on the machine.
 Ethernet - Rated Speed / Ethernet 1 - Rated Speed, Ethernet 2 - Rated Speed (Type 2
(T2) model only)
Set the communication speed for the Ethernet interface.
Note • The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [Ethernet - Rated Speed] is displayed. When two Ethernet interfaces are
used, [Ethernet 1 - Rated Speed] and [Ethernet 2 - Rated Speed] are displayed.

Auto
Select this to detect the Ethernet transmission rate automatically.

100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.

100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.

10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.

10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.

1000 Mbps
Select this to set 1000BASE-T as the default value.
Note • 1000BASE-T is not available for some models. An optional component is required.

Fuji Xerox DocuCentre-V C3375 Specifications

General

Print Resolution	1200 x 2400 dpi
Duplex Printing	Yes
Memory	2 GB
Hard Disk	160 GB
Warm-up Time	30 seconds or less
Scan Resolution	600 x 600 dpi
Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Max Paper Size	A3
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB, Ethernet
Paper Size	A3, A4, A5, B4, B5, Custom sizes
Scan Speed	70 ipm (A4, duplex)
Fax Resolution	400 x 400 dpi