Fuji Xerox DocuCentre-V C3375 Administrator's Guide

3 Maintenance
94
Maintenance
3
5 Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
6 With grasping the orange lever of the staple
cartridge, push the staple cartridge into its
original position until it clicks into place.
7 Close the finisher front door.
Note • If the front door is not closed completely, a message appears and the machine will remain paused.
Replacing Booklet Staple Cartridge (for Booklet Maker Unit for Finisher-B1)
When the Booklet Maker Unit for Finisher-B1 (optional) is installed and the booklet staple
cartridges need to be replaced, a message appears on the touch screen. When this message
appears, replace the booklet staple cartridges with new ones.
Important • The use of booklet staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only booklet staple cartridges recommended by Fuji Xerox.
Note • To order a booklet staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher side cover.
2 Hold the tabs on both sides of the booklet
staple cartridge and pull it out.
1
2

Fuji Xerox DocuCentre-V C3375 Specifications

General

Print Resolution	1200 x 2400 dpi
Duplex Printing	Yes
Memory	2 GB
Hard Disk	160 GB
Warm-up Time	30 seconds or less
Scan Resolution	600 x 600 dpi
Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Max Paper Size	A3
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB, Ethernet
Paper Size	A3, A4, A5, B4, B5, Custom sizes
Scan Speed	70 ipm (A4, duplex)
Fax Resolution	400 x 400 dpi