Fuji Xerox DocuCentre-V C3375 Administrator's Guide

16 Appendix
664
Appendix
16
11 Confirm the result of sample printout.
12 Adjust the alignment again if necessary. (Steps 5 to 11)
13 Select [Save].
14 Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
Z Fold Position Adjustment
Adjust the Z fold position.
1 Select [Z Fold - A4 ] or [Z Fold - 8.5x11" ],
and then select [Change Settings].
2 Select [Sample Printout].
3 Select the tray in which you loaded paper, and
press the <Start> button.
The sample is printed.
4 Select [Close].
5 Check the sample printout, measuring the A
and B fold position movement amounts.
6 Enter the values you measured in step 5 in
[Values A & B Before Adjustment], and the
value to which to adjust in [Desired Values A &
B].
Important • Set value A and value B so that an edge of
the paper does not extend beyond a fold
position of the paper. Extending an edge of
paper beyond a fold position of the paper
may cause a paper jam.
7 Select [Adjust].

Fuji Xerox DocuCentre-V C3375 Specifications

General

Print Resolution	1200 x 2400 dpi
Duplex Printing	Yes
Memory	2 GB
Hard Disk	160 GB
Warm-up Time	30 seconds or less
Scan Resolution	600 x 600 dpi
Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Max Paper Size	A3
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB, Ethernet
Paper Size	A3, A4, A5, B4, B5, Custom sizes
Scan Speed	70 ipm (A4, duplex)
Fax Resolution	400 x 400 dpi