Fax Service Settings
267
Tools
5
Memory Full Procedure
If there is insufficient hard disk memory while scanning a document, a screen appears
asking you how you want to handle the partially stored data.
Set the process you want the machine to perform for the partially stored data after a certain
time has elapsed in the confirmation screen.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto Job Release" (P.161).
Delete Job
Deletes the data partially stored.
Run Job
Treats the read-in data as valid, and start scanning the document partially stored.
Maximum Stored Pages
Set the maximum number of pages stored for a fax document. You can specify from 1 to
999 pages.
Mixed Size Originals Scan Mode
Set the scan mode when the machine scans documents of various sizes simultaneously with
the document feeder. If only documents of standard sizes are to be scanned, we
recommend that you select [Standard Size Mode].
Note • When [Standard Size Mode] is selected, image loss may occur if the following types of documents
are scanned:
- Non-standard size documents
- B4 size documents with the inch series setting in [Paper Size Settings].
Skip Blank Pages
Set whether or not to detect blank pages while scanning 2 sided documents and transmits
only pages that are not blank.
Note • This feature is for service representative use. For more information, contact our Customer Support
Center.
Fax Data in Folder Priority 1 to 3
Set the priority to display the fax information received using folders. For instance, when
using Network Scanner Utility 3, the fax information is displayed in the [Recipient] section
of the file list screen.
There are priority levels from 1 to 3. All priority can be set, however, if you want to display
only one priority level, make the settings of all priority levels the same.
Direct Fax
Set whether or not to receive a fax, which is instructed using a fax driver from a computer.
When you select [Disabled], the Direct Fax feature becomes unavailable.
Block Inbound Faxes
Set a G3 ID (fax number) from which you want to reject a fax reception. You can specify up
to 50 G3 IDs.
You can find the G3 ID of the sender that you want to reject in "Remote Station" column of
an Activity Report or "Input Source" column of a Job History Report.
Block Unknown Fax Numbers
Set whether or not to receive faxes from unknown G3 ID fax numbers. When [Yes] is
selected, the machine does not receive faxes from unknown fax numbers.
To Next Page
Loading...
Need help?
General
