3 Copy
168
Copy
3
Note • The supported paper orientation is only . Select the tray whose orientation is set to .
• [Z Fold] and [C Fold] can only be applied to A4 and 8.5 x 11" paper.
• This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• When the C3 Finisher is installed, making the fold assisting crease on a paper is available. For more
information, refer to "5 Tools" > "Common Service Settings" > "Maintenance" > "Fold Assisting
Crease" in the Administrator Guide.
1 Select [Folding].
2 Select any option.
Off
Does not fold copies.
Z Fold
Folds copies in three with the printed side inside or outside.
C Fold
Folds copies in three with the printed side inside or outside.
Single Fold
Folds copies in half.
Image Inside Fold
Folds copies so that the image is printed inside.
Image Outside Fold
Folds copies so that the image is printed outside.
Image Position
Image Inside Fold
Folds copies so that the image is printed inside after you select [Z Fold], [C Fold], or [Single
Fold].
Image Outside Fold
printing surface
comes outside
printing surface
comes inside
printing surface
comes inside
printing surface
comes outside
To Next Page
Loading...
Need help?
General
