7.1 Replacing the Drum/Toner Cartridge 75
Replacing the Drum/Toner Cartridge
1. Open the front cover while pressing the
front cover open/close levers of the printer.
Important
• Do not touch any parts inside the printer.
2. Hold both sides of the top cover by the grip
and open it slowly.
3. Hold the drum/toner cartridge by the grip
and pull it out slowly as shown in the
diagram.
Note
• To prevent the toner from dirtying the floor, lay a piece
of paper on the floor first before putting the drum/toner
cartridge down.
• Be careful not to dirty your hands or clothes with the
toner. If your hands or clothes are stained with it, wash
it off immediately.
4. Take the new drum/toner cartridge out of
the box and shake it 7 to 8 times as shown
in the diagram.
5. Place the drum/toner cartridge on a flat
surface and pull out the seal horizontally.
Important
• When pulling out the seal, pull it out horizontally. The
tape might break if it is pulled out at an angle.
• After the seal has been pulled out, do not shake or
bump the drum/toner cartridge.
To Next Page
Loading...
Need help?
General
