6.6 Error Messages (In Alphabetical Order) 121
Login Error
Press SET
User is not registered in authentication to print. Contact your system administrator.
Open & Close
Front Cover
Paper is jammed in the Manual Feeder.
Removed the jammed paper, and then open and close the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Open Front Cover
Clear Jam from B
Paper is jammed inside the printer. Press the side button to open the front cover and
clear the paper jam.
Refer to
"6.1 Clearing Paper Jams" (P. 102)
Open Front Cover
Clear Jam from D
Paper is jammed inside the printer. Press the side button to open the front cover and
clear the paper jam.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Open Front Cover
Clear Jam from E
Paper is jammed inside the printer. Press the side button to open the front cover and
clear the paper jam.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Open NNN
Clear Jam
Open & Close
Front Cover
(NNN:Tray1,Tray2)
Paper is jammed inside Tray 1 or Tray 2. Clear the paper jam. Open and close the
front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Out of Memory
Press SET
The printer memory is full and cannot continue processing the current print job.
• Press the <Eject/Set> button to clear the message, cancel the current print job,
and execute the next print job, if any.
• Press the <Cancel Job> button to cancel the print job.
• Press the <Menu> button to open the Print Menu and delete the pending job.
• To avoid this error in the future, do as follows:
-Delete unnecessary fonts, macros, and other data in printer memory.
-Install additional printer memory.
PDL Error
Press SET
A PDL emulation error has occurred.
• Press the <Eject/Set> button to clear the message, cancel the current print job,
and execute the next print job, if any.
• Press the <Cancel Job> button to cancel the print job.
Press SET
to Continue
Press the <Ejject/Set> button to print, and the <Cancel Job> button to stop printing.
Ready to Print
Clean CTD Sensor
The CTD sensor (automatic density control sensor) is dirty. Clean it.
Refer to
• " Cleaning the CTD Sensor" (P. 173)
Reboot printer
(NNN-NNN)
The printer is not working correctly due to damage or malfunction. Turn the printer off
and then on. If the error continues, contact our Customer Support Center or your
dealer.
Reboot Printer
(061-370)
An internal error has occurred. Turn the printer off and on. If the error continues,
contact our Customer Support Center or your dealer.
Fatal Error
(094-351)
The life of the belt unit has expired.
Contact our Customer Support Center.
Message Condition/Reason/Action
To Next Page
Loading...
Need help?
General
