177 Using the Operator Panel Menus
• Initialize NVM
Purpose:
To initialize NVM for system parameters. After executing this function and rebooting the printer, all the
menu parameters, except the parameters for the network, are reset to their factory default values.
See also:
• "Resetting to Factory Defaults" on page 183
• Non-GenuineToner
Purpose:
To use toner cartridge of another manufacturer.
NOTE:
• Using non-genuine toner cartridges may make some printer features unusable, reduce print quality and
decrease the reliability of your printer. Fuji Xerox recommends only new Fuji Xerox brand toner cartridges for
your printer. Fuji Xerox does not provide warranty coverage for problems caused by using accessories, parts,
or components not supplied by Fuji Xerox.
• Before you use toner cartridge of another manufacturer, be sure to restart the printer.
Values
• Adjust Altitude
Purpose:
To specify the altitude of the location where the printer is installed.
The discharge phenomenon for charging the photo conductor varies with barometric pressure.
Adjustments are performed by specifying the altitude of the location where the printer is being used.
NOTE:
• An incorrect altitude adjustment setting leads to poor printing quality, incorrect indication of remaining toner.
Values:
Secure Settings
Use the Secure Settings menu to set a password to limit access to the menus. This prevents
items from being changed accidentally.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
Off* Does not use toner cartridge of another manufacturer.
On Uses toner cartridge of another manufacturer.
0m* Specifies the altitude of the location where the printer is installed.
1000m
2000m
3000m
To Next Page
Loading...
Need help?
General
