Before using
8
Press and hold
for 3 seconds.
1. Press and hold the ( ) button of the
Control Wheel and buttons and
power on / off button ( )
simultaneously for 3 seconds.
2. After the pilot button flashes
for 5 seconds, the flash beeping
stops.
3. Pairing is now complete.
• Do not operate the flash until the
pairing process is completed.
• If you have multiple flashes,
you can press and hold some
flashes first to make a beep sound,
and then press and hold this unit
once at the end to pair them at once.
Commander EF-W1
Setting
Pairing is complete
when the flash beep
stops.
Pilot button blinks
for 5 seconds
* Press the Pilot button of the Commander EF-W1 for test flash.
WIRELESS COMMANDER EF-W1
The pairing settings will remain stored even if the power is turned off.
Caution
!
To Next Page