NOTES:
• The air conditioner custom code is set to
prior to shipment. To change the custom code,
contact your retailer.
• The remote controller resets to custom code
when the batteries on the remote controller are
replaced. If you use a custom code other than code , reset the custom code after replacing
the batteries.
• If you do not know the air conditioner custom code setting, try each of the custom codes ( →
→ → ) until you find the code that operates the air conditioner.
STEP 2: Selecting the function number and setting value
1. Press the SET TEMP. (
) ( ) buttons to select the function
number. To switch between the left and right digits, press the
MODE button.
2. Press the FAN button to proceed the setting value. To return the
function number selection, press the FAN button again.
3. Press the SET TEMP. ( ) ( ) buttons to select the setting value.
To switch between the left and right digits, press the MODE but-
ton.
4. Press the SLEEP button, then after you hear the beep emitted
from the indoor unit, the START/STOP button in the order to con-
firm the settings.
5. Press the RESET button to cancel the function setting mode.
6. After completing the function setting, be sure to disconnect the
power supply and then reconnect it.
*1: Small
is displayed on the right of the custom code during the
function setting.
CAUTION
After disconnect the power supply, wait 30 seconds or more before reconnecting it. The function
setting will not become active unless the power supply is disconnected and then reconnected.
DESIGN & TECHNICAL MANUAL
- 18 -
WALL MOUNTED
ASYG07-12LLCE
To Next Page
Loading...
Need help?
General
