Fujitsu AOYG18KBTA3 - Page 206


Input signal type
• Indoor unit
Input signal type is only "Edge".
Edge
• External input and output PCB
The input signal type can be selected.
Signal type (edge or pulse) can be switched by the DIP switch 2 (SW2) on the External input and
output PCB.
Edge
Pulse
The width of pulse must be
longer than 200 msec.
- 198 -
12-5. Ceiling type 12. External input and output
3-UNIT MULTI-SPLIT TYPE 3-UNIT MULTI-SPLIT TYPE