7. Press the
button once to transmit the function setting information. 1 short beep will be emit-
ted from the indoor unit or the IR receiver when the signal is received correctly. If wrong code is
set, no beep sound will be emitted.
NOTE:
Press
button within 30 seconds after pressing MODE button.
For the function details, refer to Chapter 15-5. "Function details" on page 300.
8. Exit the function setting mode by pressing the RESET button.
Setting up each indoor unit
Repeat step from 1. to 8. to set up each indoor unit. If the custom code is other than " ", steps from
1. to 2. and 8. need to be performed.
- 279 -
15-2. Indoor unit (setting by wireless remote controller) 15. Function settings
3-UNIT
MULTI-SPLIT TYPE
3-UNIT
MULTI-SPLIT TYPE
To Next Page
Loading...
