Fujitsu ARYG24LHTBP - 12-2.Remote Controller Master;Slave Setting

- 68 -
DUCT TYPE ARYG18-54LHTBP
12-2. Remote controller master/slave setting
1. Touch the [RC Master/Slave Setting] on the “Initial Setting” screen.
2. “RC Master/Slave Setting” screen is displayed. Select the [Master] or [Slave].
NOTES:
• Set only one Master remote controller. Units specified other than [Master] are set to [Slave] auto-
matically.
• Do not perform “RC Mater/Slave Setting” during setting or operating from the Master remote
controller.
Back
Previous
Page
Page 3/ 3 Initial Setting
RC Master/
Slave Setting
R.C. Master / Slave Setting
Cancel OK
Master
Slave