02-03
2-1-2 WIRED REMOTE CONTROLLER DISPLAY (OPTION)
2-Wire
1. If an error occurs, an error icon appears on the “Monitor mode screen”.
Touch the [Status] on the “Monitor mode screen”.The “Status” screen is displayed.
For the details of the indoor unit or outdoor unit error , refer to the error codes in each installation manual
2. Touch the [Error Information] on the “Status”screen. The “Error Information”screen is displayed.
(If there are no errors, the [Error Information] will not be displayed.)
3. 2-digit numbers correspond to the error code in the table below. Touch the [Next page]
(or [Previous page]) to switch to other connected indoor units.
1. Check the error
Mode Set Temp.
Fri 10:00AM
Menu
Monitor Back
Page 1/ 4
Page 1/ 5
Air Flow Direction
Economy
VT
Individual
Error Code
Address
[ 1 ]
[ 02 01 ]
[ 14 . 15, 41 . 44 ]
[ ]
[ Off ]
Next
Page
Next
Page
Error
Information
Status
Status
Error Information
Fan
!
1. 2. 3.
To Next Page
Loading...
Need help?
General
