6. SYSTEM DESIGN
FUNCTION SETTING
(5) Press the “MODE” button to access the
function setting mode.
(6) Press the “
p
” or the “
q
” buttons to select
the function number.
Press the “MODE” button to switch between
the left and right digits.
(7) Press the FAN button to proceed to setting
the number. (Press the FAN button again
to return to the function number selection.)
(8) Press the “
p
” or the “
q
” buttons to select
the setting number.
Press the
“MODE” button to switch between
the left and right digits.
(9) Press the “TIME MODE” button once to
send the function mode information.
Pi Pi
(10) Press the “START/STOP” button once to
the unction setting.
A beeping noise will be heard if the
command is accepted.
*Wrong code: No Response
Pi Pi
Note: Please push the "START/STOP" button within 30
seconds after pushing the "TIME MODE" button.
FUNCTION DETAILS
Refer to 5-6. FUNCTION DETAILS
Change digit
Change digit
- (06 - 60) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
Need help?
General
