Fujitsu AST13PSA–W User Manual

About three seconds later, the entire display will
reappear.
When set to AUTO :
Heating :
Fan operates so as to optimally circulate warmed
air.
However, the fan will operate at very low speed
when the temperature of the air issued from the
indoor unit is low.
Cooling :
As the room temperature approached that of the ther-
mostat setting, the fan speed becomes slower.
Fan :
The fan alternately turns on and off; when on, the
fan runs at the low fan speed.
The fan will operate at very low setting during
Monitor operation and at the start of the Heating
mode.
When set to QUIET:
SUPER QUIET operation begins. The indoor unit’s air-
flow will be reduced for quieter operation.
• SUPER QUIET operation cannot be used during Dry
mode. (The same is true when Dry mode is selected
during AUTO mode operation.)
• During SUPER QUIET operation, Heating and
Cooling performance will be reduced somewhat.
Example :
When set to COOL
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 @5).
Each time the button is pressed, the fan speed
changes in the following order.
– 61 –
OPERATION
To Select Mode Operation
Press the START / STOP button (Fig. 6 @6).
The Indoor Unit’s OPERATION Indicator Lamp
(red) (Fig. 3 t) will light.
The air conditioner will start operation.
Press the MASTER CONTROL button
(Fig. 6 @1) to select the desired mode.
Each time the button is
pressed, the mode will
change in the following
order.
About three seconds later,
the entire display will reap-
pear.
1
2
AUTO COOL DRY
HEAT FAN
AUTO HIGH MED
QUIET LOW
To Set Thermostat
Press the SET TEMP. SET TIME button
(Fig. 6 @2).
button :
Press to raise the thermostat setting.
button : Press to lower the thermostat setting.
• Thermostat setting range:
AUTO . . . . . . . . . . 18 to 30 °C
Heating . . . . . . . .
16 to 30 °C
Cooling/Dry . . . . .
18 to 30 °C
About three seconds later, the
entire display will reappear.
The thermostat setting should be considered a
standard value, and may differ somewhat from the
actual room temperature.
In order to increase the drying effect during quiet
cooling operation, the fan of the indoor unit may
stop.
Example :
When set to COOL
Example :
When set to 26 °C

Fujitsu AST13PSA–W Specifications

General

Brand	Fujitsu
Model	AST13PSA–W
Category	Air Conditioner
Language	English