6. SYSTEM DESIGN
DIP SWITCH 1 SETTING
SW2 setting
Dual remote controller setting
Set the remote controller SW2 according to the following table.
(
u
...Factory setting)
Number
of remote
controller
Primary unit Secondary unit
SW2 SW2
u
1 (Normal) OFF -
2 (Dual) OFF ON
SW4 setting
°F / °C switch
Temperature display is Fahrenheit(°F) / Celsius(°C)
(
u
...Factory setting)
SW4
u
OFF °C
ON °F
SW6 setting
Memory backup setting
Set to ON to use batteries for the memory backup.
If batteries are not used, all of settings stored in memory will be deleted if there is a power
failure.
(
u
...Factory setting)
SW6 Memory backup
u
OFF Invalidity
ON Validity
1 231 23
1 2 3
Indoor unit
Remote controller cable
Primary
unit
Secondary
unit
Remote controller
- (06 - 92) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
