Fujitsu AU*A45LCLU - Page 39

- (01 - 36) -
CASSETTE TYPE AU

A45-54LC
CASSETTE TYPE AU

A45-54LC
CONTENTS OF FUNCTION SETTING

Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in •
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value. •
Settings will not be changed if invalid numbers or setting values are selected. •
1-1 Filter sign
1-2 Ceiling height
1-3 Outlet directions
1-4 Vertical wind direction adjustment range
1-5 Cooler room temperature correction
1-6 Heater room temperature correction
1-7 Auto Restart
1-8 Indoor Room Temperature Sensor Switching Function
1-1. Setting the lter sign
The indoor unit has a sign to inform the user that it is time to clean the lter. Select the time setting
for the lter sign display interval in the table below according to the amount of dust or debris in the
room. If you do not wish the lter sign to be displayed, select the setting value for "No indication".
(

. . .Factory setting)
Setting Description Function Number Setting Value

"Standard
(2,500 hours)"
11
00
"Long interval
(4,400 hours)"
01
"Short interval
(1,250 hours)"
02
No indication 03
1-2. Setting the ceiling height
Select the setting values in the table below according to the height of the ceiling.
(

. . .Factory setting)
Setting Description Function Number Setting Value

Standard
3.2m
20
00
Low ceiling
2.7m
01
High ceiling
4.2m
02
The ceiling height values are for the 4-way outlet.
Do not change this setting in the 3-way outlet mode.
1-3. Setting the outlet directions
Select the setting values in the table below for using a 3-way outlet.
(

. . .Factory setting)
Setting Description Function Number Setting Value

4-way
22
00
3-way 01