D2619 (RX/TX300 S5) Technical Manual 33
Features Settings with switches and jumpers
3.8 Settings with switches and jumpers
DIP switches
Figure 12: DIP switches
I Default setting switch 1 to 4 is Off.
Recovering system BIOS - switch 1
Switch 1 enables recovery of the old system BIOS after an attempt to update
has failed. To restore the old system BIOS you need a Flash BIOS medium (see
the BIOS manual or please call our customer service centre).
Skipping the password query - switch 2
Switch 2 is used to define whether the password is queried at system startup, if
the password protection is enabled in BIOS Setup (in Security menu, the
Password on boot field must be set to Enabled).
on The system boots from the “Flash BIOS medium“ (floppy disk, ODD, USB
stick) and reprograms the system BIOS on the board.
off The System BIOS is started with the system BIOS from the system board
(default setting).
on The password query is skipped. Passwords are deleted.
off The password query is effective (default setting).
ON
1234
To Next Page
Loading...
Need help?
General
