Preparing for use
Fujitsu Technology Solutions 9
Vertical operating position
Proceed as follows to operate the device in the vertical operating position:
► If necessary, disconnect the cables.
► Position the casing vertically so that the ON/OFF switch is located at the bottom.
► Pull off the foil from the rubber / plastic feet that you will find in the accessories package.
57 mm
6 mm
37 mm
1
1
1
1
► Glue the rubber/plastic feet (1) on the casing wall.
In order to ensure that the device is stable, the position of the rubber/plastic feet must
correspond to the given dimensions.
► Place the unit on the rubber / plastic feet and reconnect any cables disconnected previously.
!
The set-up direction is specified. The ON/OFF switch must be at the top to ensure
sufficient ventilation.
To Next Page
Loading...
