|Host interface cards |
7. Place the HIC on a flat, static-free surface.
What to do next
Go to Upgrade host interface card.
Upgrade host interface card
You install the new host interface card (HIC) to increase the number of host ports in your storage array.
Before you begin
• You have an ESD wristband, or you have taken other antistatic precautions.
• You have a #1 Phillips screwdriver.
• You have two HICs, that are compatible with your controllers.
• You have removed the HIC that is being upgraded.
About this task
Attention: Possible loss of data access – Never install a HIC in an AB6100 controller canister if that
HIC was designed for another ETERNUS AB controller. In addition, both controllers and both HICs must
be identical. The presence of incompatible or mismatched HICs causes the controllers to lock down
when you apply power.
Procedure
1. Unpack the new HIC and the new HIC faceplate.
2. Align the single thumbscrew on the HIC with the corresponding holes on the controller, and align the
connector on the bottom of the HIC with the HIC interface connector on the controller card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of the controller
card.
51
To Next Page
Loading...
