Fujitsu ETERNUS AB Series - Page 63

|Host port protocol conversion|
b) Select the Support Center tile.
c) On the Support Resources tab, locate and select the Storage Array Profile link.
d) Type feature pack submodel ID in the text box, and click Find.
e) Locate the feature pack submodel ID for the starting configuration.
3. Using the feature pack submodel ID, locate the corresponding Controller submodel ID for the starting
configuration and find the Feature Activation Code for the desired ending configuration within the
following table. Then, copy that Feature Activation Code to a text file.
Note: If you are not using the IB HIC, you can ignore the HIC Ports column in the following tables:
Table 1: Encryption Capable Feature Activation Codes
Starting configuration Ending configuration
Controller
submodel ID
HIC ports Controller
submodel ID
HIC ports
Feature
Activation Code
444 NVMe/IB443 NVMe/FC
or
NVMe/RoCE
448 FC
443 NVMe/RoCE444 NVMe/FC
or
NVMe/IB
448 FC
443 NVMe/FC
or
NVMe/RoCE
448 FC
444 NVMe/FC
or
NVMe/IB
Note: If your controller submodel ID is not listed, contact Fujitsu Support.
4. In System Manager, locate the Feature Enable Identifier.
a) Go to Settings > System.
b) Scroll down to Add-ons.
c) Under Change Feature Pack, locate the Feature Enable Identifier.
d) Copy and paste this 32-digit number to a text file.
63